An Introduction to Design of Concrete Slabs on Grade for Professional Engineers

Lingua: inglese

Editore: Independently Published Jul 2026, 2026

9798188874315

Serie: Libro 76 di 76 - Structural Engineering

Da: AHA-BUCH GmbH, Einbeck, GermaniaAHA-BUCH GmbH

Venditore con 5 stelle

Venditore AbeBooks dal 14 agosto 2006

Brossura

Condizione: Nuovo

EUR 60,72

EUR 35,00 spedizione 
Spedito da Germania a U.S.A.

Quantità: 2 disponibili

Aggiungi al carrello
Resi gratuiti per 30 giorni

Descrizione dell’articolo da parte del venditore

Neuware - There are several factors that have a considerable effect on determining the design thickness of a concrete slab-on-ground and can be divided into above and below slab-on-ground factors. The type, strength, and uniformity of the subgrade or subbase are the below slab-on-ground factors and are discussed. The type of loads, magnitude of loads, and frequency of moving loads travel are the above slab-on-ground factors and are addressed. The concrete mixture design and strength of the slab-on-ground is discussed. In this discussion, the key factor in the design of a slab-on-ground-its thickness, h. Three classical design methods and the finite element (FE) method are available to engineers for determining the slab-on-ground thickness. The classical design methods are: Corps of Engineers (COE), Portland Cement Association (PCA), and Wire Reinforcement Institute (WRI). They are based on continuous support to the slab-on-ground and uniform modulus of subgrade strength, k. The slab thickness calculation is insensitive to minor changes in k-values; therefore, it is not critical to obtain an accurate k-value. It is, however, directly related to the strength of concrete defined by the concrete flexural strength, fr, which is measured in accordance with ASTM C78. The COE and WRI methods use a value equal to 7.5, while PCA method uses a value equal to 9. For heavy loading, however, it is recommended to use the lower factor of 7.5 with a factor of safety equal to 2; refer to Section 3-10. The FE method, Section 5-12, unlike the classical methods, does allow for variable modulus of subgrade in the analysis. Slabs-on-ground are designed for the critical load or load combinations that generate the maximum stress and maintain surface cracking at an acceptable level. Typically, forklifts control the flexural design of slabs-on-ground, storage racks control punching shear and concrete bearing design, while distributed live loads control negative moment design in aisles between distributed loads, dowels at joints, and settlement of slabs-on-ground; refer to Figure 5-1 (Packard 1996). Accordingly, the SER will design the overall slab-on-ground thickness for the allowable moving load that controls flexural stresses. The SER will then check for punching shear of concentrated, line, and distributed loads at localized areas where constructed, applied, or both, verifies that excessive settlement does not occur below a stationary load, and ensures that cracks are not developed in aisles between distributed loads. The design procedure covers subgrade conditions, steel reinforcement, and various details such as jointing, dowels, and the inclusion of vapor retarder, if needed.…

Codice articolo 9798188874315

Titolo
An Introduction to Design of Concrete Slabs on Grade for Professional Engineers
Autore
J. Paul Guyer
Editore
Independently Published Jul 2026
Anno di pubblicazione
2026
Condizione
Neu
Rilegatura
Taschenbuch
Lingua
inglese
ISBN 13
9798188874315
Peso dell'articolo
256 grammi
Dimensioni
279x216x5 mm
Serie
Libro 76 di 76: Structural Engineering

AHA-BUCH GmbH

Einbeck, Germania

Venditore con 5 stelle

Venditore AbeBooks dal 14 agosto 2006

Tariffe di spedizione da Germania a U.S.A.

ArticoloDa 7 a 10 giorni lavorativiDa 5 a 7 giorni lavorativi
Primo articoloEUR 35,00EUR 45,00
I tempi di consegna sono stabiliti dai venditori e variano in base al corriere e al paese. Gli ordini che devono attraversare una dogana possono subire ritardi e spetta agli acquirenti pagare eventuali tariffe o dazi associati. I venditori possono contattarti in merito ad addebiti aggiuntivi dovuti a eventuali maggiorazioni dei costi di spedizione dei tuoi articoli.

Metodi di pagamento

  • Visa
  • Mastercard
  • American Express
  • Carte Bleue
  • Apple Pay
  • Google Pay
  • Assegno
  • Bonifico bancario
  • PayPal

Descrizione dello Store

Das Unternehmen AHA-BUCH GmbH: Seit der Gründung von AHA-BUCH im Juli 2005 ist unser Hauptziel, zufriedenen Kunden so schnell und so preisgünstig wie möglich ihren Bücherwunsch zu erfüllen. Unsere Firma beschäftigt 16 Mitarbeiter, die nur ein Ziel kennen: den Kunden und seine Wünsche! Auf über 3700 m2 Fläche haben wir über 100.000 Bücher, Modernes Antiquariat und Spiele auf Lager.

Specializzazione

Kinderbücher & Kinderhör Casetten, German Books, Software, Natur & Tiere, Ratgeber, Sachbücher, Englische Bücher, Medizin & Gesundheit, Universität & Studium

Informazioni sull’azienda del venditore

AHA-BUCH GmbH

Garlebsen 48
Einbeck, Germania 37574