Foto dell'editore

Modular Permanent-Magnet Synchronous Motors with high Electromagnetic Utilization

Csaba Zsolt DeŠk

ISBN 10: 3844009582 / ISBN 13: 9783844009583
Editore: Shaker Verlag Apr 2012, 2012
Nuovi Condizione: Neu Rilegato
Da Rhein-Team Lörrach Ivano Narducci e.K. (Lörrach, Germania)

Libreria AbeBooks dal 11 gennaio 2012

Quantitŗ: 1

Compra nuovo
Prezzo: EUR 48,80 Convertire valuta
Spedizione: EUR 12,00 Da: Germania a: U.S.A. Destinazione, tempi e costi
Aggiungere al carrello

Riguardo questo articolo

Neuware - Variable speed electric drive systems became very important in recent years in many ranges of mechanical engineering as replacement for mechanical drive components, based on their technical advantages and cost reduction possibilities, due to the continuous developments in this area. Industrial customers are looking for compact drive systems with small volume, which offer higher efficiency and a reduced heat generation. Therefore, a big demand exists for electrical drives with high power- and torque density, which produces at the same time small losses. Basically, all types of electrical motors can be used in drive systems, but not many of them could fulfill all of these demands. The most widely used drive motors are asynchronous induction motors, permanent magnet (PM) synchronous motors and switched reluctance motors. The best solution for general purpose seems to be the permanent magnet synchronous motor, due to its high efficiency and good dynamic and variable speed properties. It also presents the highest development potential at the moment, as its power- and torque density can be increased with the use of high energy rare earth permanent magnets, combined with flux concentration and reluctance torque. The efficiency can be further improved by using the tooth-wound coil technology, which reduces the losses in the stator windings. The aim of this thesis was to develop two permanent magnet excited synchronous motors with 45 kW rated power and speeds up to 3000 rpm, as an alternative to squirrel cage asynchronous motors, used nowadays in the middle power range. Different motor topologies are considered, in order to find the best solution for the given requirements. This thesis deals with the design optimization of two high-torque density permanent magnet motors with different kinds of water jacket cooled stator and PM rotor using the tooth-wound coil technology, being fed by inverter, for typical industrial applications as variable speed drives. Details of the design and manufacturing process of the motors, the testing conditions and applied computation methodology are presented. The two prototype motors have fractional slot numbers per pole and phase 1/2 (two layer winding) and 1/4 (single layer winding with intertooth), and were designed for continuous rated power of 45 kW between the rated speed of 1000 rpm and a maximum speed of 3000 rpm, but the measurements proved that the field weakening can be extended up to 5000 rpm. Segmented magnets were used for the rotors in order to reduce the rotor eddy current losses due to the concentrated stator winding, which determines a high harmonics content of the air gap field. As comparison, a rotor with nonsegmented magnets was also considered and measured in combination with the original stators, but proved to generate too high losses in the magnets, which heat up the magnets above their thermal limit. The water jacket cooling of the stator gives at rated operation a thermal reserve of 30 K at 1000 rpm to the Thermal Class F limit temperature for the basic motors. Thus it was possible to increase the power for the rated speed up to 53 kW, which corresponds to 34.8 kNm/m3 per active motor volume, including winding overhangs. 194 pp. Englisch. Codice inventario libreria 9783844009583

Fare una domanda alla libreria

Dati bibliografici

Titolo: Modular Permanent-Magnet Synchronous Motors ...

Casa editrice: Shaker Verlag Apr 2012

Data di pubblicazione: 2012

Legatura: Buch

Condizione libro:Neu

Condizione sovraccoperta: Dust Jacket Included

Descrizione libreria

Visita la pagina della libreria

Condizioni di vendita:

Allgemeine Geschäftsbedingungen (

Rhein-Team Lörrach, Inhaber Ivano Narducci e.K., Mühlestr. 1
D-79539 Lörrach, nachfolgend als Verkäufer bezeichnet.

§ 1 Allgemeines, Begriffsbestimmungen

(1) Der Verkäufer bietet unter dem Nutzernamen rhein-team unter der Plattform insbesondere Bücher an. Die folgenden Allgemeinen Geschäftsbedingungen (AGB) gelten für die Geschäftsbeziehung zwischen dem Verkäufer und dem Kunden in ihrer zum Zeitpunkt der Bestellung gültigen Fassung. Ferne...

Ulteriori informazioni
Condizioni di spedizione:

Die Ware wird innerhalb von 1-3 Tagen nach Bestelleingang verschickt. Bitte entnehmen Sie den voraussichtlichen Liefertermin Ihrer Bestellbestštigung. Die Versandkostenpauschalen basieren auf Durchschnittswerten fŁr 1 kg schwere BŁcher. ‹ber abweichende Kosten (z.B. wegen eines sehr schweren Buches) werden Sie gegebenenfalls vom Verkšufer informiert.

Informazioni dettagliate sul venditore

Tutti i libri della libreria

Metodi di pagamento
accettati dalla libreria

Visa Mastercard American Express Carte Bleue

Assegno PayPal